SavarMobile

MOST WELCOME TO OUR COMMUNITY MY BROTHER / SISTERS

" ENJOY STAY HERE "

= WELCOME TO SAVAR MOBILE FORUM =

= PLEASE REGISTER FOR WHICH CAN NOT LOG-IN =
= WE ARE GLAD THAT IF YOU WANT TO SHARE EXPERIENCES WITH SCIENCE AND WE HERE =


= WARM GREETINGS =
SavarMobile


    GUIDE: How to flash M8800 Pixon

    Share
    avatar
    mehedi
    ® FORUM OWNER ®


    Posts : 593
    Join date : 2010-10-08
    Age : 24
    Location : http://savar.goodforum.net/forum.htm

    GUIDE: How to flash M8800 Pixon

    Post by mehedi on Fri 03 Dec 2010, 12:17 pm

    GUIDE: How to flash M8800 Pixon



    [You must be registered and logged in to see this link.]



    First thing to always remember, is BACK UP YOUR PHONE, Pictures,wallpapers,music, and any contacts you have saved on your phone. I am not responsible for any damage to you, your phone, computer, or lost of data in this process. This is a guideline intended for professional technicians.
    USE AT YOUR OWN RISK!!!
    1. USB cable that came with your phone.
    2. Samsung PC Studio 3 witch can be found here:
    [You must be registered and logged in to see this link.]
    Install this software first, it contains the drivers for your phone, and has every thing you need for backup.
    3. Multiloader v5,50 [You must be registered and logged in to see this link.]
    5. Newest unbrranded firmware [You must be registered and logged in to see this link.]

    -----------------------------Now you are ready to begin-----------------------------------
    1. Make sure Samsung PC Studio is installed and communicates with your phone. And unpack the firmware in a folder you can easily find it.
    2. Remove the Sim and MicroSD from your phone and replace the battery.
    3. With the phone OFF connect the phone and computer with the USB cable.
    4. While holding the no. 9 button on the phones key pad, tap the power button, the phone screen will come on black with a red stripe that says "Download" ( For Tocco and Pixon users : Hold down the "Volume -" button on the left side, and the "Camera" button on the right, then press the "Power" button = all three buttons need to be pressed together. Your phone should start up into a red\blue on black bootloader screen.)

    5. Now run MultiLoader v5.33
    6. Select the radio button that includes MSM6275/MSM6280.

    7. Select Boot Change and Full Download.
    8. Then click Boot, and select the boot files from the unpacked firmware folder.

    9. Click the Amss, Rsrc1, and Rsrc2.
    10. Then press the Factory FS tab, and select the appropriate files from the firmware folder also.
    11. Select (Low).r2c NOT (Mid).r2c. (Phone may not restart if you select mid)
    12. FOTA and ETC fields are left blank.

    13. Click the Port Search button, it will find your phone and show the com port is ready.
    14.Click the download button and be patient, this will take a few minutes to complete.

    15.When it's finished, it will show "ok complete".

    16.Unplug the phone from the USB cable, reinstall the sim, MicroSD, and power up the the phone.
    17. Now with every thing complete, perform a hard reset by typing *2767*3855# into the hand set.
    18. When the phone resets type *#1234# into your handset to check your new firmware ver.



    ###IF ANY FILE NOT FOUND SEARCH IN GOOGLE-I HOPE YOU GOT IT###

      Current date/time is Tue 12 Dec 2017, 11:37 am